The front struts are held in by (3) nuts under the hood and (2) bolts that hold them to the wheel bearing knuckles. If you have access to a 1/2" pnuematic impact wrench the removal process will take about 5 minutes per strut. You will need a strut spring compression tool to compress the spring and remove the strut mount. I recommend replacing the strut mounts when you replace the struts as the are a wear item. Removing the nut that hold the strut to the strut mount will require a box wrench and a 6mm Allen wrench, put the box wrench on the nut and use the Allen wrench to turn the strut rod. This is also easily removed by the 1/2" pnuematic impact wrench.
Reassembly is the reverse of disassembly. You will need to have a wheel alignment performed when you are done as the cast/camber of you tires will be off and will cause severe tire wear.
Good Luck
replacing mirror on Saturn 1999if its anything like the 2002 sl2 just pop the plastic piece off the inside, and remove the screws, unplug it, and replace it, follow steps in reverse to put it back together, takes about 5 minutes or so lil_dipper_98
if it is anything like my 97' Saturn Sl2. The engine must be dropped out to dismount the transmission.
Replacing the Saturn L300 fuel pump will cost approximately $450. The exact cost is dependent upon several factors, such as the rate for labor.
If you can afford it, replace both. if one side is worn out, odds are the other side will soon be worn too.
I had a similar problem and ended up replacing both the lines and the radiator.
Easy place, just hard to describe. It is located on the side of the engine, not front or back. It is located on the drivers side. A little below and back of the the upper radiator hose. (I RECOMMEND WHEN REPLACING THE SENSOR, TO ALSO REPLACE THE WIRING FOR IT TOO, GM SELLS THE NEW HARNESS FOR IT).
how to replace the thermostat on a 2005 saturn relay3
NEED to??? No. But the question becomes, why are you replacing the camshaft? You should always replace the lifters when replacing the camshaft. A worn camshaft usually indicates that there will be other wear as well, but if you just want to squeeze a few more miles out of the engine, you might be able to get by with just replacing the cam and lifters.
Did You replace the EGR valve! Happened to me!
It is NOT the same as a 4cyl. I had to remove the air filter box and the right-side engine mount in order to replace this belt
Start by replacing all the spark plugs. If that does not solve the problem then replace the spark plug wires.
How can I replace the headlamp on a 2000 Saturn SL1