answersLogoWhite

0

Take the old one out and put the new one in...

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How do you replace a dimmer switch for a 1987 Chevy truck 4x4?

how do you replace3 dimmer switch 1987 chevy silverado 4 x 4


Where is the flasher found on a 2004 Chevy Impala?

The flasher is built into the hazard switch. You need to pull the dash to replace the switch. It costs about $45 & is available through Chevy dealers. Mike The flasher is built into the hazard switch. You need to pull the dash to replace the switch. It costs about $45 & is available through Chevy dealers. Mike


Replace switch that control fan speed for vent in Chevy silverado?

Change blower fan control switch in the dash


Replace fuel filter 2008 Chevy Silverado?

replace fuel filter 2008 Chevy silverado


How do you fix hazard button in 1995 Chevy s10?

Usually not repairable, you will have to replace the complete multifunction switch.


How do you replace the turn signal switch on a 2003 Chevy Silverado.?

The 2003 Chevrolet Silverado turn signal switch is located below the dashboard, on the drivers side of the passenger compartment. The turn signal switch simply plugs in and out.


Does a 1994 Chevy Silverado have a fuel switch?

No.


How do you bypass a neutral safety switch on a 2004 Chevy silverado 1500?

How do u bypass the neutral safety switch in a 2002 chevy silverado 1500


How do you replace fuel injectors Chevy Silverado?

how do i reinsert the fuel injectors on my 4.3 Chevy silverado


Does 2001 Chevy Silverado have a kill switch where?

NO, They were not used on chevy trucks.


Does the 96 Chevy silverado have an inertia switch if it does where is it located?

No, it does not have an inertia switch.


How do you replace ignition switch on a 1986 Chevy silverado?

To replace the ignition switch on a 1986 Chevy Silverado, first disconnect the battery to prevent any electrical issues. Remove the steering column cover by unscrewing it, then locate the ignition switch, which is typically mounted on the steering column. Disconnect the wiring harness from the old switch, remove the mounting screws, and replace it with the new ignition switch. Reassemble the steering column cover, reconnect the battery, and test the new switch to ensure it functions properly.