How do you replace the hazard switch
The flasher is part of the hazard switch and they are replaced as a unit. Remove the trim piece from the dash. This is attached with screws in some places and press fit in others. Once the trim is loose it is a simple matter to replace the switch.
On my 2001 it is part of the Hazard switch. You have to replace the entire switch on a 2001.
The flasher circuit is in the hazard switch in the dash.
turn signal switch is the hazard button! Pull out hazard button and replace it! good luck!
1998 chevy malibu programe new switch
If the turn signals are inoperative check the hazard switch, if the hazards don't work replace the hazard switch, the signals will start working. if the hazards are ok ,the turn signal switch may be bad.
which relay!!
If the hazard switch in your 2001 Malibu continues to click even after replacing it and the fuse, the issue may lie in the wiring or the relay associated with the hazard lights. Check for any damaged wires or poor connections that could be causing a short circuit. Additionally, the clicking might be related to the turn signal relay, which could be malfunctioning. Inspecting and potentially replacing the relay may resolve the issue.
in my 2001 A4, it was the hazard light switch that had to be replaced. maybe thaqt's your issue also
Try turning the hazard flashers on and off a couple times, see if that starts your signal lights working. If so, replace the hazard switch/module.
its built on with the hazard switch. all you have to do is remove the center vent press the clips together to the left through the vent and slide out the hazard switch. All you have to so after that is order the hazard switch module from www.gmpartsdirect.com. hope this helps...