If you are talking about the bulb only you open the hood and on the back ot the headlight assembly you will see a large gray cylinder turn it to the right as far as it will go then pull the bulb out of the assembly hole. After you have it out hold the clip on the side of the blub up a little and pull the bulb from the socket. If you are talking replacing the headlight assembly itself you have to loosen and remove 3 nutd from the rear of the assembly just on the inside of the back of the assembly. there isn't much room in this space a small rachet or a racheting wrench will work fine. After you have the 3 bolts loosened and removed you have to take the rubber seal around the outside edge off the old assembly and put it on the new 1 unless you got new seals. Then just reverse the steps to put the new 1 back in. I just recently replaced all the front lights on my 93 the headlights were yellowed pretty bad. Good luck. If you are replacing all 3 lights like i did on the dricers side i had to reach in from undreneath to get at the drivers side inner little light. I couldn't reach it from above. Have fun. It probably took me about 2 hours to do all 6 light assemblies.
from the inside of the hood maybe?
the headlight adjustment screws on a 1987-1993 ford mustang are behind the headlights in the engine compartment. there is a radiator core support directly behind the headlights, between the headlamp and the core support is where the adjustment screws will be found. They are very small (4MM) hex head adjusters.
You can get a new top for your 1993 Mustang at Mustangs Unlimited.
Ford Mustang SVT Cobra was created in 1993.
Yes
now rated at 260 hp The 1993 Ford Mustang was rated between 205-225hp
can anyone tell me how to remove a transmission from a 1993 ford mustang 4 cylinder? Thanks sailtome69@yahoo.com
No, it will not.
Not without major modification, no.
Not directly, no.
1992/1993 mustang GT, COBRA, or SALEEN.
replace the printed circuit board behind the tach gauge. $15.00