remove the two bolts holding it in (5/16" i believe) un-clip the wiring connector, use a new gasket and reinstall it torquing the bolts to 89 in/lbs (10 nm) reconnect the connector and you should be all set
How do you replace the EGR Valve on a 2001 Ford Escape?
The idle control valve is mounted on the side of the throttle body. Carbon building up in the valve will cause the engine not to run properly.
remove it from the engine
Replace the heater control valve motor, a dealer part, costs around $166.00.ish
how do you replace the valve cover gasket on a 2002 mitubishi lancer
Yes but it is computer controled .If it's bad you can clean it or replace it.
Where is the fuel idle control valve for a 2002 Pontiac Sunfire
To replace the idle control valve on a 2002 Jeep Liberty Sport, first, disconnect the negative battery terminal to ensure safety. Next, locate the idle air control valve on the throttle body, disconnect the electrical connector, and remove the two screws holding the valve in place. After removing the old valve, clean the mounting surface, install the new valve, and secure it with screws. Finally, reconnect the electrical connector and the battery terminal, then start the engine to ensure proper operation.
just unbolt the valve
how much does it cost to replace to egr valve on the 2002 mazda protege
Idle air control valve diagram
heater Control valve for 2002 Lincoln Ls