0
Disconnect the battery. First you need to remove the lock cylinder. To remove it, with the key in the ignition, you will need to insert a pin in the small hole on the lock cylinder to release it, I usually use the end of a paperclip. Once it is released, it should turn counter-clockwise past the accessory position and slide out. You will notice the retaining ring around the switch has three slots cut into it. Use a flat screwdriver and gently tap it to turn the retaining ring counter-clockwise... It's basically a nut. You can pull it out from behind the dash. Unhook the tabs on the plug and unplug it. Plug the new one in, slide it back through the hole, install and tighten the retainer nut. The lock cylinder should just slide right in in the same position it came out. Once it's in, simply turn it to the off position and you are done. Re-connect the battery.
What else can I help you with?
How is the Starter wired on a 1969 Chevelle?
The battery cable on the positive side goes to the starter. The purple wire goes from the ignition switch to the neutral safety switch then down to the starter. On the solenoid the is a "R" and that is where the wire from the coil goes. The "R" means resistor
Where is the brake light switch on a 1969 Chevelle?
It's on top of the brake pedal under the dash.
Will a 1970 chevelle front bumper fit a 1969 chevelle?
No it will not.
What color wire is the ignition switch on a 1969 camaro?
purple is the trigger wire for the starter. Yellow is the ignition wire.
Can the front clip of a 1969 Chevelle mount onto a 1967 Chevelle body?
No it will not.
Will a 1969 two door Chevelle doors fit on a 1970 two door Chevelle?
No they will not. Only 1970-1972 doors will fit on a 1970 Chevelle. 1969 is only interchangeable with 1968.
How do you replace an ignition cylinder on a 1969 Pontiac gto?
To replace the ignition cylinder on a 1969 Pontiac GTO, first disconnect the battery to ensure safety. Remove the steering column cover by unscrewing the necessary screws, then locate the ignition switch. Use a flathead screwdriver to turn the ignition cylinder to the "on" position, press the release tab, and pull out the cylinder. Install the new ignition cylinder by reversing the steps, ensuring it locks in place securely before reassembling the steering column cover.
How do you remove an ignition switch from a 1969 vw bus?
To remove the ignition switch from a 1969 VW Bus, first disconnect the battery to ensure safety. Then, remove the steering column cover by unscrewing the screws holding it in place. Once exposed, locate and unscrew the ignition switch from its mounting, carefully disconnect the wiring harness, and pull the switch out. Reassemble everything in reverse order once the new switch is installed.
What is the original paint color of a 1969 Chevelle transmission dip stick?
The original paint color of a 1969 chevelle transmission dip stick was black.
What is the top speed of a 1969 Chevelle?
about 130 mph
How do you fix glove box latch for 1969 Chevelle?
If there is no adjustments on it you will have to buy a new lock from a chevelle website such as yearone.com.
How much did a Chevrolet Chevelle cost in 1969?
what model chevelle?, it all depends if your talking about the cheap model or the SS.
