How do you replace the map lights in a 2000 Chrysler 300m?

Answer 1

REMOVAL

Open hood, disconnect and isolate the negative

battery cable.

Remove the overhead console retaining screw,

located in the front of console near the windshield.

Using your fingertips, grasp the sides of the

overhead console and pull straight down evenly to

disengage the two snap clips at the rear of the unit.

Lower the overhead console far enough to

access the wire harness connectors.

Disconnect the control module, courtesy lamps

and if equipped, the power sunroof switch electrical

connectors.

Remove the lamp and socket assembly from the

overhead console.

Remove the lamp bulb by pulling it straight

out of its socket.

INSTALLATION

Position the overhead console in the vehicle

and connect the wire harness connectors.

Connect the control module, courtesy lamps

and if equipped, the power sunroof switch electrical

connector.

Using your fingertips, grasp the sides of the

overhead console and push straight up evenly to

engage the two snap clips at the rear of the unit.

Install the overhead console retaining screw,

located in the front of console near the windshield.

Torque the screw to 1.2 N·m (10 in. lbs.).

Connect the remote negative battery cable.