its located on the exuast pipe it screws into the pipe and pluggs into another connector unplug it unscrew it screw the new one in then plung it back into the connector
There is no fuse for the oxygen sensor. The only fuse is for the ECM. --------------------------------------------------------------------------------------------------------- On a 1997 Ford Explorer, there is a 20 amp mini fuse for the Hego system (heated exhaust gas oxygen sensor) in location # 11 in your power distribution box in the engine compartment. THE PD BOX IS LIVE - DISCONNECT YOUR BATTERY CABLES (Helpfull)
the oxygen sensor or 02 sensor is usually located on you headers it should take a 5/8 wrench it will have two wires coming off of it.
Bank 2 is the drivers side of the engine in a Ford Explorer Sensor 1 would be somewhere in the exhaust before the catalytic converter ( upstream )
A 1997 Dodge with a Cummins diesel does not have an oxygen sensor.A 1997 Dodge with a Cummins diesel does not have an oxygen sensor.
how do you replace rear wiper motor on a 1997 ford explorer
its screwed into the exhaust manifold,undo wire and unscrew at manifold.
The 1997 Ford Explorer ambient temperature sensor can be found on the bottom of the drivers side mirror. The engine coolant temperature sensor can be found on the front of the engine.
The only fix is to replace it. If you are mechanicly inclined, this is a doable deal. Before you replace the sensor you should check the wiring for resistance you can use a volt/ohms meter (vom) and test the continuity of the wiring to the sensor.
The 1997 Ford Aerostar oxygen sensor is screwed into the exhaust pipe. It is about even with the rear of the oil pan.
how do you replace the camshaft position sensor on a 1997 plymouth voyager 3l
The upstream heated oxygen sensor is located ahead of the catalytic converter The downstream heated oxygen sensor is located behind the converter
2