0
Unplug sensor cable from connector. Use 7/8" Oxygen Sensor socket, available at most auto supply and tool stores for around $10, to remove the sensor (It's a deep well with a slot cut up the side to clear the four wires that come out of the end of the sensor) . Insert new sensor using the same socket. The threads should have anti-seize compound already applied to them by the manufacturer. That is adequate. Plug the sensor connector into it's mate. That one is done. There are two Oxygen sensors on my '97 Wrangler. One is in the downpipe just after the connection to the exhaust manifold and the other is just after the catalytic converter. Easy to do!
What else can I help you with?
How do you change the oxygen sensor on a 1997 Jeep Wrangler?
Use a 02 socket. The 2 sensor are located in front and behind the cat.
Where is the oxygen sensor on a 1997 Dodge turbo 3500 5.9 Cummins diesel?
A 1997 Dodge with a Cummins diesel does not have an oxygen sensor.A 1997 Dodge with a Cummins diesel does not have an oxygen sensor.
Where is the IAT sensor on a 1997 Jeep Wrangler 4-cylinder?
on the intake
How do you replace Oxygen Sensor in 1997 Nissan Pickup?
its screwed into the exhaust manifold,undo wire and unscrew at manifold.
How do you fix a p0141 problem code on a 1997 ford ranger?
The P0141 code on a 1997 Ford Ranger indicates a problem with the oxygen sensor heater circuit for the bank 1 sensor 2. To fix this issue, first, inspect the wiring and connectors leading to the oxygen sensor for any damage or corrosion. If the wiring is intact, test the sensor itself and replace it if faulty. Additionally, check the fuse related to the oxygen sensor heater circuit and replace it if necessary.
What are the names of the potentiometer sensors on a 1997 jeep wrangler?
The throttle position sensor is a potentiometer.
How do you fix an oxygen sensor on a 1997 Accord?
The only fix is to replace it. If you are mechanicly inclined, this is a doable deal. Before you replace the sensor you should check the wiring for resistance you can use a volt/ohms meter (vom) and test the continuity of the wiring to the sensor.
Where is the oxygen sensor on a 1997 Ford Aerostar?
The 1997 Ford Aerostar oxygen sensor is screwed into the exhaust pipe. It is about even with the rear of the oil pan.
Where is the cranck position sensor on 1997 jeep wrangler 6-cylinder 4.0?
bellhousing driverside
How do you replace the camshaft position sensor on a 1997 Plymouth voyager 3 L?
how do you replace the camshaft position sensor on a 1997 plymouth voyager 3l
How do you replace a oxygen sensor on a 1997 Dodge Grand Caravan?
To replace the oxygen sensor on a 1997 Dodge Grand Caravan, first ensure the vehicle is cool and disconnect the battery to prevent electrical issues. Locate the oxygen sensor, typically found on the exhaust manifold or near the catalytic converter, and use a wrench or O2 sensor socket to remove it. Install the new sensor by threading it in carefully and tightening it securely, then reconnect the battery. Finally, clear any error codes from the vehicle's computer if applicable and start the engine to check for proper function.
Where is the oxygen sensor on the 1997 Elantra?
The upstream heated oxygen sensor is located ahead of the catalytic converter The downstream heated oxygen sensor is located behind the converter
