0
You must first remove the transmission and fly-wheel. Then you will see the 1 piece
seal on the crank shaft. Pry it out, it will pop out. Then install new seal in it's place.
A seal driver is the best tool to use. Be sure you clean the area good, and put some oil on the crankshaft before sliding the seal over the crank.
What else can I help you with?
Can i have main bearings for a 1995 Chevy s10?
You can use main bearings on a 1995 Chevy S10. The bearings can be purchased at most auto parts stores.
What is the fuel tank capacity of a 2007 Chevy suburban?
31 gallons main fuel tank.
Does a 1999 Chevy suburban 350 have a 2 bolt main or 4 bolt main?
1500--2 bolt, 2500 4 bolt
How much to replace the main fuse in a Chevy trail blazer?
$2
How do you replace 2001 Chevy silverado rear main seal?
How do you change a rear main seal on a 2001 Chevy 2500 HD long bed
Fuse for washer pump on Chevy Suburban?
The fuse for the washer pump is the same as the wipers. The fuse is in the main power distribution box.
Do you have to remove transmission to replace the rear main oil seal in a 2000 Chevy cavalier?
You must remove the transmission are engine to replace the rear main seal.
How do you replace the main fuel lines on a 1995 Buick LeSabre?
get a new car!
Where is the PCM driver circuit located on a 1995 Chevy G20 van?
It is integral to the main ECU
How do I replace the Rear main engine seal on a small block Chevy?
You will need to remove the transmission.
How do you replace a rear main seal on a 1995 Chevy beretta v6?
To replace the rear main seal on a 1995 Chevy Beretta V6, first, disconnect the battery and remove the transmission to access the engine's rear. Drain the engine oil and unbolt the oil pan to remove it, which may require disconnecting the exhaust system and crossmember. Once the oil pan is off, remove the old rear main seal from the crankshaft, clean the sealing surfaces, and install the new seal carefully. Reassemble by reversing the disassembly steps, ensuring all components are properly aligned and torqued to specifications.
How do you change the pittman arm on a 1996 Chevy Suburban?
You need a wedge tool to separate the arm from the main steering rod , then unfasten the two bolts and it is off .
