0
Remove the lens backet set screw located at the top of the lens - this is done with the hood up. The backet connects the lens to the frame body. G-E-N-T-L-E-Y place a large screw driver between the headlight lens and the trun singal lens and slowly pry the signal lens forward. The lens is held in place by a 3 - 4 inch tube that connects by presure into the frame. You'll need to apply enough presure to dis-engage the tube. It will pop out giving you access to all the lights contained in the lens. It's easy to pop it back in - remember to replace the set screw under the hood.
What else can I help you with?
Where is the thermostat located on a 1996 isuzu trooper?
On top in front of engine
How do you change the rotors in the front on a 1994 Isuzu Trooper how do you remove the front hubs?
wear gloves, bearings all come out. then you have to remove the sensor off the back of it. along with 6 17mm bolts. How do you change the rotors in the front on a 1998 Isuzu Trooper
Where is the thermostat located on a 1998 Isuzu Trooper?
The thermostat on a 1998 Isuzu Trooper is located on the front of the motor. It is in the top radiator hose where it connects to the motor. To access the thermostat, the hose needs to be disconnected from the motor.
How do you replace 2002 isuzu trooper front wheel bearing?
To replace the front wheel bearing on a 2002 Isuzu Trooper, first, lift the vehicle and remove the front wheel. Next, remove the brake caliper and rotor to access the hub assembly. Use a suitable tool to remove the hub nut, then detach the hub assembly from the knuckle. Finally, press the old bearing out and press in the new bearing, reassemble all components in reverse order, and ensure everything is properly torqued.
Where is the oil filter on a 1992 Isuzu trooper?
passenger side of motor, top, in front of fire wall
How do you replace a marker light on the right front for a 1998 Isuzu trooper?
To replace the right front marker light on a 1998 Isuzu Trooper, first, ensure the vehicle is turned off and the keys are removed. Open the hood and locate the marker light assembly; then, remove the screws or clips holding the assembly in place. Carefully pull the assembly out, disconnect the wiring harness, and replace the old bulb with a new one. Reconnect the wiring, secure the assembly back in place, and test the new light to ensure it works.
Firing order 99 Isuzu trooper 3.5l?
The firing order for a 99 Isuzu Trooper 3.5l is 1, 2, 3, 4, 5, 6. The number one cylinder is on the left side in the front as you are facing the car.
1990 4-cylinder Isuzu trooper how many seats?
you have two seats in the front, and a bench seat in the back
How do you clean 2000 Isuzu trooper 30 diesel front brake calipers to stop them from sticking and prevent the hubs from getting very hot?
Cleaning will not help. The piston is going cocked in the bore. Rebuild or replace.
How do you replace the shocks on a 1997 Isuzu Rodeo?
How do I remove the front shock bottle pin of my Isuzu rodeo 2000
How do you replace the front turn signal bulb?
trouble putting right front signal bulb in.
Where is the starter on an 1988 Isuzu Trooper?
just behind the wheel well of the right front tire its a silver color looking thing
