Remove negative battery connection and keep it away from battery. Lift truck or jack up truck in RF corner. Remove torque convertor cover. Remove both starter through bolts. There might be another bracket to the block for stabilizing and if there is, remove the one bolt for this. The starter will be loose now so support it. Gently twist and lower a little to gain access at the solenoid connections and remove both nuts for these. Slip cables off and the starter is on the ground. Clean connections including grounding area to block and reverse this to install.
the starter GMC Yukon?
on top of the starter. you have to disconnect battery then remove starter to replace it
Drain the water from your 1997 GMC Yukon cooling system. Remove the water supply hose. Remove the thermostat housing retaining bolts. Remove the old thermostat and replace with the new thermostat.
for the 1997 4x4 4 door gmc yukon, GM uses the 6lug on 5.5in
On a 2001 GMC Yukon, the starter is located on the passenger side of the engine, mounted to the bell housing where the engine meets the transmission. It is positioned towards the bottom of the engine, making it somewhat difficult to access without raising the vehicle. To replace or service the starter, you may need to remove the protective cover or other components for better access.
wiring diagram of a/c system for 1997 gmc yukon
How do I replace the fuel fiter on my 2000 gmc Yukon 5.3 XL?
How many gallons of gas coupon 1997 Yukon hold
no
it is located on the fuel rail .
intake manifold is under the throttle body
There is no filter on a 2003 yukon, GM stopped inside filters in 2002