get a automotive repair manual (haynes) 30016 (610)
To change the starter on a 1993 Dodge Colt, first disconnect the negative battery cable to ensure safety. Then, locate the starter, which is typically mounted near the transmission; remove the electrical connections and the mounting bolts holding it in place. Replace the old starter with the new one, reattach the bolts and electrical connections, and finally reconnect the battery cable. Make sure to test the new starter before closing everything up.
Knowing the firing order of a car's engine can help diagnose engine problems. The firing order of a 1987 Dodge Colt Vista is 1-3-4-2.
Dodge Colt was created in 1970.
This is an easy bolt-on part. If you really can't see how to do it, get a manual for the car.
The starter location on a 1992 Dodge Colt 100E is typically found on the lower passenger side of the engine, near the transmission bellhousing. To access it, you may need to remove some components or protective covers. It's advisable to consult the vehicle's service manual for specific instructions and diagrams.
Replacing the front left and right CV joint axles on a 1987 Dodge Colt DL 1.5L typically takes a mechanic about 2 to 4 hours. The time can vary based on the mechanic's experience and the condition of the vehicle. Factors like rust or corrosion may also affect the time required for the job.
where is a ignitionmodule in a dodge colt a 1993
Its located on the a/c compressor, its the one with the larger hose (suction side)...
According to my 1987 dodge colt shop/repair manual it can be either ;Low fluid,transmission linkage cable needs adjusting or,could also be elctircal,Check PCSV wiring.tran fuse. hope this can help
Brakes on a Dodge Colt? It would depend on what is wrong with them, what they are doing or not doing.
The starter on the 1993 Plymouth Colt is mounted on the back side of the engine (by the firewall), and below the intake manifold.