answersLogoWhite

0

Removal # Disconnect battery ground cable (14301). # Raise vehicle on a hoist. # Disconnect wiring from starter terminals. # Remove attaching bolts and remove starter motor (11001). Installation # Position starter motor and hand-start attaching bolts. # Snug all bolts while holding starter motor squarely against its mounting surface and fully inserted into pilot hole. # Tighten bolts to 20-27 Nm (15-20 lb-ft). # Connect wire at solenoid S-terminal. # Position battery cable on solenoid B-terminal and install attaching nut. Tighten nut to 9-14 Nm (80-124 lb-in). # NOTE: When the battery (10655) has been disconnected and reconnected, some abnormal drive symptoms may occur while the powertrain control module (PCM) (12A650) relearns its adaptive strategy. The vehicle may need to be driven 16 km (10 miles) or more to relearn the strategy. Lower vehicle and connect battery ground cable. Check operation of starter motor.

User Avatar

Wiki User

16y ago

What else can I help you with?