Loosen rad petcock or one end of lower hose to drain rad. Remove the 2 or 3 bolts on water outlet housing. Tap gently to remove the outlet. Remove stat from outlet. Clean gasket surface. Install new stat the same way old one came out with new gasket with sealer or o-ring. CAREFULLY snug the 2-3 bolts evenly so as not to break the housing. Add coolant, keep rad cap off for 20 minutes to bleed out air and fill with coolant. Check for leaks. Done. I hope this helps you. Mark
where is the thermostat located on 95 buick regal
depends on the engine size
How do you replace the fuel filter on a 2003 Buick Regal?
were can i locate and replace a starter for a 1998 buick regal?
How do you replace the morror assembly for a 2001 Buick Regal
The thermostat is usually located in the housing where the upper rad hose is clamped to the engine.
how to replace a radiator in a 1996 buick regal
The PCV valve for a 1999 Regal 3.8 is located on the top of the valve cover. The valve pulls out to replace it.
You have to get it from a Buick dealer.
how to replace master cylinder on 1996 buick regal
Look for the upper radiator hose. The hose will go from the radiator to the top front of the engine. The hose will connect to the engine through the thermostat outlet housing. The thermostat is located under the thermostat outlet housing.
Where is the knock sensor located on a 1992 buick regal