The thermostat is in a housing on the engine end of the top radiator hose. Drain the cooling system and remove the hose at the housing. Remove the bolts and the housing. Clean the intake manifold and the housing. Install the thermostat and gasket and then the housing and hose. Close off the radiator drain and refill.
follow top radiator to end of hose, the thermostat is in the housing at end...
follow top radiater hose to it,it is hard to access housing!!! for thermostat, the thermostat is at the end of the lower intake manifold on drivers side of engine.
how to replace actuator on a 2000 malibu
The 2000-2005 Chevrolet Impala only came with a 3.4 and 3.8 V6 (6 cylinder) engines. Are you sure that you don't have a Malibu instead? at the emd of the upper rad hose you will find the thermostat housing. Take the 2 bolts out and remove it. When reinstalling it make sure the spring on the thermostat goes toward the engine.
Take a small common screw driver and twist it in the seam.
how DO YOU REMOVE AN IGNITION CYLINDER FROM A MALIBU CHEVROLET 2000
Replace thermostat on 2000 vw jetta
map sensor 2000 malibu location
I doubt it very much as they change engine specs every year.
5w-30w is best.
The thermostat opens at 195 degrees and the temperature will rise to 232 to 235 degrees before the cooling fan comes on to cool it down.
Remove the 2000 Chevrolet Malibu washer tank supply hose. Remove the windshield washer tank retaining bolts. Reverse the process to install the new windshield washer tank.