steps
drain coolent, remove belt, remove alternator, remove ac line bracket to swing out of the way, remove pump pulley, remove a number of small mounting bolts around the pump sheet metal housing.
How to change fuel pump in 1985 cadillac fleetwood
in the fuel tank
4000
Depends the model of the Cadillac. A 1980-1985 Cadillac Fleetwood Brougham coupe gross weight is 4000lbs.-4400lbs.
All Cadillac deville and Fleetwood rims from 1985 to 1993
To change the water pump on a 1985 Fleetwood Cadillac, first disconnect the negative battery cable and drain the coolant from the radiator. Remove the serpentine belt, and then detach the hoses connected to the water pump. Unbolt the old water pump from the engine block, clean the mounting surface, and install the new pump with a new gasket. Reattach the hoses, reinstall the serpentine belt, refill the coolant, and reconnect the battery.
The Cadillac Fleetwood was produced by the General Motors corporation between 1985 and 1996. It was a full-size luxury car manufactured in the United States. The Fleetwood line continued to be produced until 1999 by the Superior Coach Company of Ohio.
Assuming you're referring to the RWD Fleetwood, it could have either a 4.1L V6, 4.1L V8 or a 5.7L diesel V8
Yes, the 2-door 1985 Cadillac Fleetwood is considered rare because Cadillac produced very few 2-door versions compared to the more common 4-door models. This makes the 2-door Fleetwood sought after by collectors and enthusiasts.
Unplug the wires, unbolt the seat from the floor panel, take the seat out.
The fuel filter is on the drivers side in front of the rear wheel along the frame.
In a 1985 Cadillac Fleetwood, the fan relay is typically located in the engine compartment, near the fan motor itself. It can often be found mounted on the radiator support or near the fuse box. To access it, you may need to remove some covers or panels to reach the relay for inspection or replacement. Always refer to the vehicle's service manual for precise locations and procedures.