How do you replace the water pump on a 2000 Chrysler Town and Country?

Answer 1

check out the haynes repair guide at the auto parts store. However, the process is simple and only takes about 2 hours. 1. Lift the front right of the vehicle. 2. From underneath the vehicle remove the plastic cover that protects the water pump. Two screws mounted to the bumper and 3 plastic tacks connecting the wheel protective cover. 3. Place a large catch pan under the vehicle and disconnect the hose that is connected to the water pump. The antifreeze will come out and go into the catch pan. 4. Once completely drained clean up the area and remove the fan belt by entering from underneath the vehicle with a tension release bar. (It is very difficult to release the belt from above although it looks easier.) 5. Put a screwdriver into one of the holes on the pulley at the water pump and take out the three holding bolts. You will have to rotate the screwdriver for each of the bolts. 6. Remove the pulley and then the 6 bolts holding in the water pump. Remove the water pump and clean the surface with a paper towel or cloth. 7. put the new pump on and tighten the bolts using a cross pattern like you would on a wheel. 8. Replace the pulley with the screwdriver in place. 9. Replace the fan belt, the the hose to the water pump. 10. Fill with antifreeze. Then test the vehicle by starting it. Check for leaks. 11. If no leaks then replace the plastic cover and enjoy the rest of the day.