To replace the windshield washer pump in a 1997 Chrysler LHS, first, disconnect the negative battery cable for safety. Remove the washer fluid reservoir by unbolting it and disconnecting the hose and electrical connector. Take out the old pump from the reservoir, then install the new pump by reversing the removal steps. Finally, reattach the reservoir, reconnect the battery, and test the new pump to ensure it functions properly.
It is on the bottom of the washer fluid reservoir.
very carefully...
You have to remove the washer fluid reservoir and remove the pump from the bottom area of its side.
Remove the wiring harness from the washer pump. Remove the washer pump hose. Remove the washer pump retaining screws. Reverse the process to install the new windshield washer pump.
It is underneath the washer reservoir.
Most likely located at bottom of reservoir remove and pump should twist or pry out
I highly doubt it would work. I believe 1999-2001 or so to be the same.
Check either at the bottom of the windshield washer fluid reservoir or check to see if the wiper motor has washer hoses connected to it
Yes.
The 1997 Chrysler LHS takes 24" drivers side and 22" passenger side replacement windshield wiper blades.
where is the windshield washer fuses located in 1997 Oldsmobile cutlass supreme
Right Over The Battery