answersLogoWhite

0

Assuming the battery was disconnected during the process, you need to drive it. It may take a 100 miles or more and several cold start-up drive cycles with some city and highway miles. The fuel level in the fuel tank should also be kept between 1/4 and 3/4 full.

User Avatar

Wiki User

9y ago

What else can I help you with?

Related Questions

How do you reset a Lincoln ls computer?

Unplug battery for 30 minutes then plug back on that will reset the ecm


What kind of transmission does the 2001 Lincoln Navigator have?

The 2001 Lincoln Navigator has a 4-speed automatic.


2001 Lincoln V8 transmission?

yes...it has one


How do I reset cam shaft sensor on a 2001 Kia sportage?

always remove battery terminal when replacing sensors.That is your reset.


Where is the transmission dipstick in a 2001 Lincoln Town Car?

On a 2001 Lincoln Town Car : The automatic transmission fluid level dipstick is in the engine compartment , near the firewall , towards the passenger side of the vehicle, where the transmission is bolted to the rear of the engine


Where is the vehicle speed sensor on a 2001 Lincoln town car?

On the top of the transmission


What is the transmission diagram for a 2001 Lincoln Town Car?

446 Yx x5


How do you reset check engine warning on 2001 Lincoln Town Car?

dealer must clear


Where is the fuel pump reset on a 2001 Lincoln town car?

On a 2001 Lincoln Town Car : The fuel pump shut off switch ( inertia switch , with the reset button on top of the switch ) is located in the trunk . It is mounted on a bracket by the drivers side trunk lid hinge


Where is the reset for seats on 2001 Lincoln Continental?

there is not a reset, also you have to do is get the seats where you would like to have them and then press the memory button again and it should set to the new position.


Are there any computers that need to be reset when replacing a battery in a chrysler sebring 2001?

when you take the battery out of a vehicle, you must drive it at least 50 miles to reset all the monitors.


Where is the reset button for a 2001 ford ranger 4.0 L. engine automatic transmission?

The reset button for a 2001 Ford Ranger with a 4.0L engine and automatic transmission is typically located on the transmission itself, near the transmission pan. It may also be found on the driver's side, just above the transmission oil pan. If you're having trouble locating it, refer to the owner's manual for specific diagrams and locations.