There is no reset for the key.
There is no reset for the key.
Put a good key in the ignition and turn the key on.
You have to lock it from the outside with an extra key.
All factory Dodge systems are reset with the remote or by unlocking the drivers door with the key.
Service Reset instruction for 2007+ Sprinter with no steering wheel buttons.1. Put the key in the ignition and switch it on without starting the engine.(Wait for LCD to return to the vehicle mileage)2. Hold the "O" button down till you hear a beep (could take a while, 30 sec.)3. Press the "M" button repeatedly and a number of reset menus will appear, (If you have used oil according to quality sheet 229.31 or 228/229.51 you can scroll to Reset.31 or Reset.51 respectively.) Select "reset 51"4. Now, when appropriate oil type is selected press "O" for 6 seconds until ''2'' is displayed.5. Press "O" once again briefly and the '' reset done'' message will confirm that the job is done.6. Pull the Key out
The key are only available from a Dealer. They also have "chips" in them and need programmed.
The key has to be ordered precut from the dealer, the dealer also has to program it.
No reset is necessary.
The factory alarm is reset by unlocking the doors with a key or remote.
Your problem is the chip in the key or the ignition. Try your other key before doing anything else.
The factory alarm is reset with the remote or by unlocking the door with the key.
To reset the anti-theft alarm system on a 2007 Dodge Caliber, first ensure that the vehicle is unlocked using the key fob or the physical key. If the alarm is still activated, insert the key into the ignition, turn it to the "On" position without starting the engine, and wait for about 10 minutes until the security light turns off. After this, turn the key back to the "Off" position, and then start the vehicle. If these steps do not work, consult the owner's manual or a professional for further assistance.
The factory security system is reset by unlocking the doors with a key or remote.