The airbag light stays on when the computer has detected a malfunction and set a code. Clearing the code with out repairing the failure will not shut the light off.
In order to get your SRS Service Airbag light reset, You have to go to the Volvo dealership.
The airbag light stays on when there is a malfunction in the system. The airbag computer will need scanned to know possible causes.
how do you reset the passenger side airbag on a 2000 passat?
YOU DONT BUT TO RESET THE LIGHT AFTER REPAIR GO TOWWW.VEHIX411.COM TO SEE FREE VIDEO INSTRUCTIONSI have a 2000 CRV and the airbag deployed which caused the seatbelts to lock. How do you reset them?
The air bag light is on because there is a problem with the air bag system. Until the problem is fixed the light will remain on. When the problem is fixed the light will reset itself.
To reset the airbag light on a 2000 Daewoo Lanos, first, ensure that the vehicle is turned off. Disconnect the negative battery terminal and wait for about 10 minutes to allow the system to reset. Reconnect the battery, then turn the ignition on without starting the engine. If the airbag light remains on, it may indicate a persistent issue that requires diagnostic troubleshooting.
To reset the airbag light in a 2000 Nissan Xterra, first, ensure the ignition is turned off. Then, disconnect the negative battery terminal and leave it disconnected for about 10 minutes. Reconnect the battery terminal and turn the ignition to the "ON" position (do not start the engine) for about 10 seconds, then turn it back to "OFF." Finally, start the vehicle to see if the airbag light has reset. If it remains on, there may be a persistent issue that requires professional diagnosis.
No reset buttons on a Dodge.
To turn off the airbag warning light on a 2000 Vectra C, first ensure that all airbag connections and sensors are intact and functioning properly. If there are no issues, you can use an OBD-II scanner to reset the airbag system. Alternatively, disconnect the car battery for about 10 minutes, then reconnect it, which may also reset the light. If the warning persists, it’s advisable to consult a professional mechanic for further diagnostics.
remove neg. battery cable for 10 min. and reconnect. that should reset the light.
Take it to your Dealer for repairs. It could be any number of sensors or the contacts in the column.
You will have to have the cause of the code repaired for the light to go off.see related question below.You will have to have the cause of the code repaired for the light to go off.see related question below.