There's no reason to reset the computer. If the change oil light is on then do this.
Turn key on,do not start then push the gas pedal all the way to the floor 3 times being sure to let all the way off of it each time. Then turn key off and then start the engine. Light should go off. If not repeat steps again and this should be done within 5 seconds.
You do not have to reset the computer.
Turn key on without turning on the engine then press the gas pedal 4 times. The computer should then reset.
What about it? What do you need to know?
no after changing drive vech for 3 miles
I feel like I keep repeating the same thing over and over so i will try again. How do you reset the oil change indicator on a 2005 BMW X3. Thanks Rod53
how do you reset the check engine light on a 2005 Toyota tundra
How do you reset the message to service engine soon on 2005 Nissan terra
Hit the stautus button on the dash. While it is displaying oil life on the trip computer display hold down reset until it resets.
You need a scan tool.
There is no reset for the computer. You can disconnect the negative battery cable for 5 minutes and this may or may not reset any fault codes. If not they will have to be reset with an OBD2 scan tool.
You can reset the computer by an obd II scanner or if you dont have the money to buy one just unhook the terminals on the battery for 5 minutes and your computer will be reset hook it back up and your ready to go!
With a scan tool or a battery disconnect.