Hi,
The "Check Engine" light, or "Service Engine Soon" light is an indication of some engine or emission related problem.
The proper way to reset the light is to find out what is causing it and have that problem repaired. The first step is to connect a scan tool, or code reader, to the computer connector and find out what is causing the problem. You will get a code that indicates why the light is on, and then you can take the appropriate steps to have the problem repaired.
The problem could be as simple as a loose or broken gas cap, to some kind of problem with the ignition system or one of the sensors in the van. So get the codes from the computer and once you decode the code numbers, you will know the next step for solving the problem.
Good Luck, Greg
Disconnect the battery for approximately two minutes.
disconnect the battery for 30 seconds
unhook the positive on the battery for 5 min. This should reset your check engine light if it doesnt then you still have issues.
How do I reset the service engine light on a 2003 Chevy Trailblazer?
The Chevy venture does not have fuel reset. Some cars, like ford, kia, etc, has a fuel reset, but venture not.
How do you reset check engine light for the 2009 Chevy trail blazer?
You can either bring it in to a Chevy dealer or use a programmer/tuner to reset the check engine light.
I reset the check engine light on my jeep by disconnecting it from the battery.
after install a new compass in my chevy venture how to reset it?
It requires an engine scanner to do that.
disconnect the battery for five minutes, It will reset
The air bag light is on because there is a problem with the air bag system. Until the problem is fixed the light will remain on. When the problem is fixed the light will reset itself.