0
What else can I help you with?
How do you reset the check engine light on an 2004 Ford F150?
Without having a scan tool, you can disconnect the battery, and let sit for apx. 10 min., then reconnect.
1990 ford f150 replaced alternator good battery can not keep a charge any ideas?
defective alternator
What will run the battery down on an F150 2002 model when nothing is turned on in vehicle?
If you are 100% sure nothing is on pulling power from the battery and it will not hold a charge then the battery has a dead cell and must be replaced.
What would cause a 1994 ford f150 truck not to start?
There are a couple of a reasons why a 1994 Ford F150 truck will not start. The truck may have a dead battery or the spark plugs need to be replaced.
Your F150 will not start and will not take a jump the alternator solenoid and battery were replaced is it most likely the starter?
Starter Ignition Neutral switch
How do you change the battery on a 2001 Ford F150?
How do you remove and replace the battery on a 2001 Ford F150?
How do you disable or reset the anti-theft alarm after replacing the battery in a 1998 Ford F150?
I believe you need to just start the engine with the key, it worked for me
97 Ford F150 you hear clicking when you try to start it Battery checked good starter solenoid replaced ground wire replaced rebuilt starter and checked good What else can be wrong?
battery need to be at lease 14 volts to be able to start
Where is the Fuel reset switch on a 1986 Ford F150?
There are images available online to help you see where the Fuel reset switch on a 1986 Ford F150 is.
1995 F150 replaced engine why will the engine not turn over?
Did you attach the electric contacts to your starter? Do you have a good battery? Someone needs to check out your electrical system.
What do you do to reset the fuel switch on a ford f150?
Locate the switch and press the reset button.
How do you reset the computer on a 1992 F150?
To reset the computer on a 1992 Ford F-150, disconnect the negative battery cable and leave it disconnected for about 10-15 minutes. This will clear any stored trouble codes and reset the engine control module (ECM). After the time has passed, reconnect the negative battery cable, and your computer will be reset. Make sure to check any radio presets or clock settings, as they will also be cleared.
