The "check coolant level" message will come on when the coolant level is low in the overflow tank. If the message stays on after the tank is filled, make sure the sensor on the front bottom is connected. If the connection is O.K., then lightly tap on the side of the overflow tank with a soft rubber mallet. If the message persists after driving the car a couple of days, replace the overflow tank.
To stop the low coolant alarm and turn off the low coolant light on a 1983 Toronado, first check the coolant level in the reservoir and radiator, and refill if necessary. If the coolant level is adequate, the issue may be a faulty coolant level sensor. Inspect the sensor and its connections for damage or corrosion, and replace it if needed. Finally, disconnect the battery for a few minutes to reset the system and turn off the light.
There is no way to reset the light. If the light is on, then either the coolant is low, the float is stuck or the sensor is bad.
there is no reset you have replace the low coolant sensor and flush cooling system and use dexcool coolant.
Low coolant. If the coolant is low then the heater core is not able to transfer heat in to the car.
The coolant temperature sensor on a 2001 Jeep Cherokee is located in the intake manifold. It monitors the flow and temperature of coolant through the engine.
You should be able to reset the low coolant light by the parking light switch 3 times on and off somewhat quickly should do it
You can reset the 2001 Buick Century low coolant warning light by removing the fuse. Keep the fuse out for 10 seconds, then replace it to its original spot.
its useful to add fluid to the radiator and itll reset itself ,,,,,,,,, check coolant temp sensor.
To reset the low coolant light in a 2000 Silhouette, first ensure that the coolant level is topped off in the reservoir. Next, turn on the ignition without starting the engine, allowing the dashboard lights to illuminate. Once the low coolant light is on, press the gas pedal three times within five seconds to reset the warning light. Finally, start the engine to confirm the light has been reset.
Well, it will no light up if you have the correct coolant levels.
There are a couple of reasons why a 1996 Cadillac Seville SLS may overheat. The coolant may be low or the thermostat needs to be replaced.
add antifreeze