0
What else can I help you with?
How do you fix the security system on a 1992 Chevy Camaro when your car does not start?
"The security resistor on your key may be dirty or dead. Try a new key from GM. It will come programmed right from the dealer. Another possibility is that your ignition key also has a resistor in it. That can only mean that there is a passkey system such as the one used in a 1994 Buick Regal Custom. When the passkey system fails, it costs about $350 to replace. However, for a Camaro, it's worth the money. Take it to a garage to test the system." I own a 1991 Camaro that has the passkey, and I trip it accidentally a lot. When this is done, go under the dash and there is a brown/black/purple wire with a black connector. Unplug this, then plug it back in and the system is reset and the car should start.
How do you reset the security system on a 1999 Chevy Camaro?
You don't. You douse it with gasoline and throw a match on it.
How do you reset the Security system in a 2000 Dodge Durango?
how to reset security system in a 2001 dodge durango
How do you reset the security system on a 2004 ford explorer?
how to reset security system on ford explorer 2004
How do you reset the security system on a 2003 Nissan Xterra?
How do you reset the security system on a 2003 nissan xterra?
How To Reset Security System on 2006 Saturn Vue?
how can I reset the security system on my 06 saturn vue
How to Reset pass key on 95 Buick Roadmaster?
To reset the passkey on a 1995 Buick Roadmaster, first ensure that you have the correct key for your vehicle. Insert the key into the ignition and turn it to the "On" position without starting the engine. Leave it in this position for approximately 10 minutes until the security light turns off, then turn the key to the "Off" position for 5 seconds. Repeat this process two more times, after which the passkey system should be reset.
What is the procedure to reset vat system on a 91 camaro?
Check
2002 Chevy Malibu will not start Theft deterrent light stays on and will not reset by owners manual instructions?
From everything I have read about this, if putting the jey in the 'ACC' mode for 10-15 minutes doesn't reset the system you will most likely have to have the key cylinder replaced by the dealer. The security Passkey system will probably have to be replaced or bypassed.
How do you reset security 1995 Nissan Sentra?
How do you reset the security system 1995 Nissan Sentra?
How do you reset the security system on a Cadillac?
If you have set the alarm system off, lock the driver door, and then unlock it with the key and that should reset the security system.
Can you reset passkey II on a GM truck?
Passkey II can be reset based on the type of Truck you are looking at. You can usually reset it by the steps below. To determine if the passkey is your problem you need to know if the security light is flashing, solid, or out. Observe the Security indicator lamp in the instrument panel. Remove the key from the lock cylinder. - Security indicator should be Flashing when the door is open. - Security indicator should be Off when all the doors are closed. - If the Security indicator does not come On or go Off correctly, refer to the Content Theft Deterrent System diagnostic and repair information in the applicable Service Manual. With the Doors closed, place the key in the lock cylinder and turn to the Run position. Observe the Security indicator lamp. - Lamp is On and does not go Off however, the engine starts. This indicates that the Vehicle Theft Deterrent (Passlock) system detected a fault when the engine was running. - Lamp flashes On and Off. This indicates a problem has been detected by the Passlock(Passlock™) system and the engine may not start this key cycle, a current condition. If you determine that the Passlock is the issue, you need to do some web research on the "corrosion of the passlock system" GM had massive issueswith them and you may be able to get the answer there.
