En el panel tengo un problema con pcm 30 fuse windstar 98
Clear all PCM codes.
On a 2000 Ford Windstar, the Powertrain Control Module (PCM) AICE chip is located within the PCM itself, which is typically found under the driver's side dashboard. To access it, you may need to remove the PCM from its mounting bracket, which is usually secured with screws. The AICE chip is integrated into the PCM, so replacing the entire module is often necessary if it fails. Always consult a repair manual for specific instructions and safety precautions.
Unhook the negative battery cable for 15-30 min
One reason a 2004 Ford Freestar may stall out is because of a water damaged PCM. This is a common problem with the 2004 Ford Freestar.
Powertrain Control Module
To access the PCM, you need to remove the cowl. Once the cowl is off, you will see the PCM up in the far corner on the passenger side near the firewall
disconnect the negative battery terminal to reset the pcm computer. disconnect it for at least 20 minutes
The ASD is a relay controlled by the PCM and does not have a reset.The ASD is a relay controlled by the PCM and does not have a reset.
On a 2004 Ford Ranger ( for the 3.0 and 4.0 liter V6 engines ) In the power distribution box ( which is " live " ) in the engine compartment ( # 47 is the PCM relay ) ( # 48A is the fuel pump relay )
In the Ford Windstar, the Powertrain Control Module (PCM) is typically located in the engine compartment, mounted on the passenger side near the firewall. It may be housed in a plastic cover or enclosure. Accessing it often requires removing some components or covers, depending on the specific model year. Always consult the vehicle's service manual for precise location and removal instructions.
In the Power Distribution Box ( which is " live " ) in the engine compartment : Mini fuse # 1 is a 30 amp fuse for the PCM relay Mini fuse # 2 is a 10 amp fuse for the PCM and front electronics module Mini fuse # 5 is a 15 amp fuse for the PCM and fuel pump motor