Step one disconnect battery for one hour if that don't work step two check all fuses all good ok step three call a locksmith or you're local GM dealer for a reset will cost you 85 bucks good luck r.r
reset the average mpg reading
TIME mode: Press and Hold "Reset" CHRONO mode: Press "ST/SP" and then press and hold "Reset" TIMER mode: [Sorry, I don't know] ALARM mode: [Sorry, I don't know]
You can't just "reset" the computer to make it start. On start up, it is in a default mode. Afterward it gathers information from the sensors and compensates accordingly. It, most likely, is something else.
To reset the password on Konica Minolta printers, Enter service mode and press Stop + 0 + Clear to enter advanced security mode. Here you can set the password without knowing the original one.
on the side of it there is a reset under the lock mode button
jaguar sovereign engine failsafe mode reset
To reset the security mode in a 2004 Hyundai Santa Fe with a 2.4L engine, first, ensure that you have the key or remote that is programmed to the vehicle. Insert the key into the ignition and turn it to the "On" position without starting the engine. Wait for about 10 minutes until the security indicator light turns off, then turn the ignition off and attempt to start the engine. If issues persist, consult the owner’s manual or a professional mechanic for further assistance.
Press mode Press mode again Then press mode and reset simultanously Start/stop changes digit Reset changes between the hour, minute, day, and date
Reset your password using the verification method below:
Sleep mode.
To reset a laptop, first back up any important data. Then, go to the system settings; for Windows, navigate to "Settings" > "Update & Security" > "Recovery" and select "Reset this PC." For macOS, restart the laptop and hold down Command + R during boot to enter Recovery Mode, then choose "Erase Mac" or "Reinstall macOS." Follow the on-screen instructions to complete the reset process.
On the dash to the right of the DIC screen there are three buttons, Mode, Select, and Reset. First, push the Select button until the DIC shows the screen for Tire Pressure, once there hold the Reset button for five seconds. While holding the Reset button for five seconds the DIC screen will go from Low Tire, to xxx, release the button and it should now show Normal.