DISSCONECT YOUR BATT FOR 10 seconds...........there you have it
how do u reset the anti theft system on a 1989 cadillac eldorado
jaseph Stalin
To reset the service charging system on a 1994 Cadillac Eldorado, first, disconnect the negative battery cable and wait for about 15 minutes. Then, reconnect the cable, ensuring a secure connection. Start the engine and allow it to run for a few minutes; this should reset the system. If the issue persists, it may require further diagnosis of the charging components.
What is needed when the ccr is driver information center
go to autozone .
To reset the AC compressor in a 1996 Cadillac Eldorado, first, ensure the engine is off and the AC system is turned off. Disconnect the battery for about 10 minutes to reset the vehicle's electrical systems. Reconnect the battery, then start the engine and turn the AC back on to see if the compressor operates normally. If issues persist, it may indicate a need for further diagnosis or repair.
To reset the computer on a 1992 Cadillac Eldorado, you can disconnect the negative battery terminal and leave it disconnected for about 10-15 minutes. This will clear any stored diagnostic trouble codes and reset the engine control module (ECM). After reconnecting the battery, start the vehicle and allow it to idle for a few minutes to re-establish normal operating parameters.
To reset the AC in a 1998 Cadillac Eldorado, start by turning off the engine and then disconnect the negative battery cable for about 10 minutes. Reconnect the cable and start the engine. Next, set the climate control system to the lowest temperature setting and the highest fan speed, allowing it to run for a few minutes. This process can help reset the climate control system and restore proper function.
To reset the service CCR light on a 1991 Eldorado, disconnect the battery for 10 minutes. Reconnect it and start the car.
You would have to define exactly what you mean by 'reset' before the question can be answered.
If you have fixed the problem it should reset itself. If not, the light will stay on.
Take the negative battery cable off for about 3 min.