The light is on because there is a problem with the system. The light will remain on until the problem is fixed. Once the problem is fixed the light will reset itself after a short drive.
No.
unhook a battery cable for about 3 minutes and re-hook.
Unhook the car battery.
GM vehicles do not use inertia/reset switches.
Sometimes you can reset the security light on a Monte Carlo. Open all the doors and then lock them and close them. Next, use the key to unlock the front driver's side door. If this doesn't work, the car should be taken to a mechanic who can diagnose the problem. When the security light goes on, it can mean something in the security system is failing.
The easiest way is to simply unbolt the battery cable for a couple of minutes. However, if you haven't fixed the problem that set the check engine light it will simply come back on again.
On a 1999 Chevy Monte Carlo, the fuel pump reset switch, also known as the inertia switch, is typically located in the trunk, near the fuel tank. You can find it on the driver's side, mounted on the rear wall of the trunk. If you need to reset it, simply press the button on the switch. Always consult the owner's manual for specific details related to your vehicle.
Take it to a mechanic, and have them erase the codes. Auto zone and advance will not do it as they are not mechanics
Turn the key to on (not start) and when the dash lights come on quickly press the gas pedal to the floor three times in less than 5 seconds. This should reset the light. If not, try it again. If you have the drivers information panel you will have to go through the reset on it as described in your owners manual.
you eat 25 corndogs ! :]
General Motors cars do not have a reset switch.
how do I set reset ignition security on a 1999 z34 monte carlo