answersLogoWhite

0

To reset "CHANGE OIL" light, turn the ignition switch to the run position without starting the engine. Fully depress and release the accelerator pedal 3 times within 5 seconds

User Avatar

Wiki User

10y ago

What else can I help you with?

Related Questions

How do you reset the 'service ccr' light on a 1991 Eldorado?

To reset the service CCR light on a 1991 Eldorado, disconnect the battery for 10 minutes. Reconnect it and start the car.


How do you Reset SRS light for 1991 Eldorado Biaritz Cadillac?

You can't. The SRS light is on because the SRS (Supplemental Restraint System) has detected a fault in the system. Until it is fixed the light will remain on and the SRS will not function if needed. Once the necessary repairs are done the SRS system will reset the light itself.


How do you reset engine Light on 1991 Volvo 240 DL?

how do you reset engine light on 1991 volvo 240


How do you reset the brakelamp light on the dashboard - Honda prelude 1991?

reset the brakelamp light on the dashboard - Honda prelude 1991


How do you reset the service ccr system on the driver information center on a 1991 Cadillac eldorado?

What is needed when the ccr is driver information center


How do you reset the check engine light on a 1991 Mercedes Benz 560 sec?

How do you reset the check engine light on a 1991 mercedes Benz 560 Sel


How do you change the ignition cylinder on a 1991 Cadillac Eldorado?

Remove steering wheel and signal switch


When was Eldorado Gold created?

Eldorado Gold was created in 1991.


How do you reset the Change Oil Soon light on a 1991 Buick Park Avenue?

When "CHANGE OIL SOON" light is illuminated, find the hole in the underside of the dash on the passenger side near the door. Insert a blunt instrument into the hole and press the switch. The light will flash four times when the system is reset.


How do you reset the computer on a 1991 Cadillac Eldorado?

To reset the computer on a 1991 Cadillac Eldorado, disconnect the negative battery cable for about 10-15 minutes. This will clear the computer's memory and reset any stored trouble codes. After reattaching the cable, start the vehicle and allow it to idle for a few minutes to let the computer recalibrate. Lastly, drive the car gently for a short distance to help the system adapt to normal operating conditions.


How do you reset your check gauges light in a 1991 Chrysler 5th avenue?

There is no reset for a check gauges light. If the light is on, there is a problem either with the temperature oil pressure or voltage.


What does it mean when the maintenance light of a 1991 Honda Accord is on?

The maintenance light on all early model hondas have three stages. Green, orange and then red. This light only serves as a reminder to change your oil, air filter and to do other routine maintenance. If you were to service the vehicle and not reset the light it would just stay on. It changes color by miles. It's green when it is reset and as you drive it will eventually change to orange and then red regardless of any services done to the vehicle. To reset look on the instrument panel for a slot near the light and insert your key this will change it back to green.