With the key in the on position press the gas pedal 3 times..This should reset it>>
Answer 2: (from the owner's manual)
Do these steps in 5 seconds: Turn the key to the "ON" position while the engine is NOT running (the dash lights will turn on with all the appropriate beeps). Fully press and slowly release the accelerator pedal 3 times. Turn the key to the "OFF" position.
Start the engine normally, if the "Change Engine Oil" warning still comes on, repeat these steps. It might take you a few attempts before you do it correctly.
To reset the change oil light on a 2006 Pontiac Montana, first turn the ignition key to the "On" position without starting the engine. Then, press the accelerator pedal three times within five seconds. Finally, turn the ignition off and then back on to verify that the oil change light has been reset. If the light remains on, repeat the process.
Pontiac does not use inertia/reset switches.
I am still waiting for the answer u cant reset the abs light u have to take it to the shop, if your abs light is on there is something wrong with your trac system
To reset the check engine light on a 2003 Pontiac Montana, you can disconnect the negative battery terminal for about 10-15 minutes. This will clear the vehicle's computer memory and reset the light. Alternatively, you can use an OBD-II scanner to clear the codes directly. However, ensure that any underlying issues triggering the light are addressed to avoid future problems.
Read you owner's manual.
To reset the oil change light on a Pontiac Solstice, turn the ignition key to the "On" position without starting the engine. Then, press the gas pedal three times within five seconds. After doing this, the oil change light should reset and turn off. If it doesn’t reset, repeat the process or consult the owner’s manual for further instructions.
The check engine light has nothing to do with an oil change. The check engine light is reset with a scan tool after repairing the failure that caused it.
Not exactly sure what you're asking for here, but if you mean a fuel pump reset switch, as on a Ford, these vehicles are not equipped with it.
To reset the change oil light on a Pontiac Solstice, first, turn the ignition key to the "ON" position without starting the engine. Then, press the accelerator pedal three times within five seconds. Finally, turn the ignition off and then back on to check if the light has reset. If it remains illuminated, repeat the process.
Hold the oil/trip Reset button while ignition is on (not car) for 8 seconds
To reset the check engine light on a Pontiac Montana, you can disconnect the negative battery cable for about 15 minutes, which will clear the engine's trouble codes. Alternatively, you can use an OBD-II scanner to read and clear the codes directly. If the light comes back on after resetting, it's important to address the underlying issue that triggered it. Always consult a professional mechanic if you're unsure about diagnosing the problem.
No problem, if it's like my 2001 Montana. Just press your mileage trip button until you get to the 'oil' reading. Then, just press on same button and hold for a few seconds. It should go back to 100 (fresh oil).