answersLogoWhite

0

disconnect both terminals from the battery, then touch the terminals together, not connected to the battery, voila!

you're done.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

How many lugs does the 2002 Chevy Trailblazer have?

2002 Chevy trailblazer has a 6 lug bolt


2002 Chevy Trailblazer oxYGen sensor where is it located?

where is the O2 sensor on a 2002 chevy trailblazer


When was Chevy Trailblazer created?

Chevrolet TrailBlazer was created in 2002.


Where is the location of the fan sensor on 2002 Chevy Trailblazer?

Where is the location of the cooling fan sensor on a 2002 Chevy Trailblazer? Also what is the 800 number for Chevy?


How do you change the spark plugs on a 2002 Chevy Trailblazer?

How do you change the spark plugs on a 2002 chavy trailblazer


How do you replace a throttle body Chevy Trailblazer?

How do you replace a throttle body on a trailblazer 2002


Does the 2002 Chevy Trailblazer have a chip in the key?

Nope!!!


What transmission is in a 2002 Chevy Trailblazer 2wd?

4l60e


How to reset oil light on 2002 Chevy trailblazer?

ignition on - engine off - floor the gas pedal 3 times. That's it! LOOK IN YOUR OWNERS MANUAL!


How do you reset engine computer on a 2002 Chevrolet trailblazer?

To reset the engine computer on a 2002 Chevrolet Trailblazer, disconnect the negative battery terminal using a wrench, and leave it disconnected for about 15 to 30 minutes. This allows any residual power to drain and resets the computer. Afterward, reconnect the negative terminal, ensuring a tight connection, and start the vehicle. You may need to re-enter radio codes or reset other electronic settings after this procedure.


How do you disconnect the front fuel line on a 2002 Chevy Trailblazer?

www.trailvoy.com Trailblazer enthusiasts forum!


How you reset the computer on Chevy prism 2002?

To reset the computer on a 2002 Chevy Prism, you can disconnect the negative terminal of the battery and leave it disconnected for about 15 minutes. This allows the vehicle's computer to reset. After reconnecting the terminal, start the car and let it idle for a few minutes to allow the computer to recalibrate. Alternatively, you can use an OBD-II scanner to clear any error codes directly.