0
To scan a 1993 Ford E150, you need an OBD-I (On-Board Diagnostics) scanner, as this vehicle predates the OBD-II standard. Locate the diagnostic connector, typically found under the dashboard near the steering column. Use a compatible scanner or a jumper wire to connect pins in the connector to initiate the diagnostic mode, allowing you to retrieve any stored trouble codes. Refer to the vehicle’s service manual for specific instructions on interpreting these codes.
What else can I help you with?
Where is the iat location on a 1993 e150 van?
What does IAT stand for
Where is rear blower motor on 1993 Ford e150 van?
in the rear
What size speakers are in a 1993 ford E150 conversion van?
6x8
How many gallons of gas does a 1993 ford e150 van hold?
My 1992 E150 has a 35 gallon tank so I'm guessing your E150 is the same even though it is only one year newer than mine.
When was The Infotainment Scan created?
The Infotainment Scan was created on 1993-04-26.
Where is the inertia switch for a 1993 E150 ford van?
Passenger side lower kick panel
Where is the Throttle position sensor located on a 1993 E150 van 5.0?
It is mounted to the throttle body.
Can the Catalytic Converter make the engine run hot on a 1993 e150 van?
Yes, if it is clogged.
Where are the fuses in 1993 ford van econ e150?
Check by driver's side firewall next to steering column
Location of fuel pump 1993 ford van e150?
Dond esta el fuel pump shut of switch del ford van 1993 e-150 ?
How do you get the air out of the aux heater in a 1993 e150 5.8 ford club wagon?
how do you get the air out of the aux heater lines on a 1993 E-150 ford club wagon with 5.8 engine?
How Maintenance reminder reset for 1993 jeep?
That is reset with a scan tool.
