Idle is computer controlled and is not adjustable. If the speed is incorrect there is a sensor or actuator malfunction.
Idle speed is not adjustable on this car.
The computer will set idle between 600 and 900 rpm depending on load and temperature..
Idle speed is computer controlled and is not adjustable. If the speed is above 1500 or below 500 there is a sensor or actuator malfunction.
There is no set interval. It only needs replaced if there is a failure.
To add Freon to a 2004 Chrysler Sebring, locate the low-pressure service port, which is typically found on the larger diameter aluminum line leading to the AC compressor. Remove the cap from the port and connect the refrigerant can's nozzle. Make sure the AC is set to the maximum cooling setting before adding Freon. Always check the system's pressure with a gauge to avoid overcharging.
Idle speed is computer controlled and is not adjustable.Idle speed is computer controlled and is not adjustable.
The marks on the sprockets line up with plated links on the chain.
When it is on the computer has detected a malfunction and set a trouble code.
To set the clock on a 1999 Chrysler Sebring Convertible, turn the ignition to the "ON" position without starting the engine. Press the "CLOCK" button on the radio or dashboard, and then use the "H" (hour) and "M" (minute) buttons to adjust the time. Once set, press the "CLOCK" button again to save the changes.
If you are asking about ignition timing there is no adjustment it is controlled by the engine controller
remove left tire and fender cover set in front of tire
Idle speed is computer controlled between 500 and 1500 rpm. It is not adjustable.