0
I did it I'm pretty sure you hold down the "clock" button until it starts blinking, if not "clock" button try holding down one of the other two but when it start blinking then hit prees then button right above it and when you get it right hit the button below clock button to switch over to min. and adust that too.
What else can I help you with?
How do you change the clock on my 1990 Mercury Cougar?
To change the clock on a 1990 Mercury Cougar, first, locate the clock or radio controls on the dashboard. Turn the ignition key to the "On" position without starting the engine. Then, press and hold the "HR" (hour) button to set the hour, and the "MIN" (minute) button to set the minutes until the correct time is displayed. Release the buttons, and the clock will be set.
How do you Set timing marks on 1999 mercury 2.5 duel cam?
do u set the timing marks at btdc or tdc on a 2.5 mercury cougar
How do you set clock on 2000 mountaineer?
'how do I set the clock on a 2001 mercury mountaineer'
How do i get a set of keys for a 1981 Mercury Cougar xr7?
Locksmith
How do you set a clock on a 1993 mercury cougar?
Hold the clock/volume knob down for 10 seconds. Continue holding and use the tune buttons. Tune left adjusts hours. Tune right adjusts minutes. Release clock/volume knob to finish.
How do you set the time on the radio display on a 1999 Mercury Tracer?
Hold clock button and volume increase or decrease to index hours of minutes.
Where do i set the timing for a 1968 Mercury Cougar?
For a 1968 Cougar with a 302 ci/ 2 bbl carb, you will want to set the timing at 6*B from TDC
How do you set clock in mercury villager van?
To set the clock in a Mercury Villager van, first turn the ignition key to the "On" position without starting the engine. Then, locate the clock adjustment buttons, usually found on the dashboard near the clock display. Press the "Hour" button to set the hour and the "Minute" button to set the minutes. Once set, the clock will retain the time after the ignition is turned off.
How do you set the clock on 1998 mercury mountaineer?
To set the clock on a 1998 Mercury Mountaineer, start by turning the ignition key to the "On" position without starting the engine. Next, locate the "Clock" or "Set" button on the radio or dashboard. Press and hold the "Set" button while using the "Hour" and "Minute" buttons to adjust the time. Release the "Set" button when you're finished, and the new time should be displayed.
What would cause a backfire on a '67 Mercury Cougar?
the ignition timing set wronge. BAd accelerator pump in the carburetor
How do I set the clock on a 1999 Chrysler Sebring Convertible?
To set the clock on a 1999 Chrysler Sebring Convertible, turn the ignition to the "ON" position without starting the engine. Press the "CLOCK" button on the radio or dashboard, and then use the "H" (hour) and "M" (minute) buttons to adjust the time. Once set, press the "CLOCK" button again to save the changes.
How do you set the clock in a 2000 mercury villiger?
Just press the hour and minute buttons on the radio.
