see owner's manual
Turn the ignition key to the on position. Turn the radio off and press the set button. Set the hour and minutes using the seek buttons.
AnswerTurn the radio off first. Press the set button. Use the scan and seek buttons to set the hour and minute.
To set the clock on a 2000 GMC truck, first turn on the ignition but do not start the engine. Locate the "Clock" button on the radio or dashboard. Press and hold the "Clock" button until the display starts blinking, then use the "Seek" or "Tune" buttons to adjust the hours and minutes. Once the correct time is set, press the "Clock" button again to save the settings.
Press the set button one time. Then to set the hour you press the seek back button to adjust. For the minutes side, you would press seek forward. Then when done press Set again.
Hold down the "arrow up" button (beside the "audio" button) and it should beep, use the same button for hrs and the "arrow down" button for mins
Hold the clock button in until the display flashes the time. Then use the channel changer button to set the time. FYI: The minutes are adjusted by pushing the right side of the button, then the hour is changed by pushing on the left side. After you get to the correct time, push the clock button again.
I found this out through trial and error. Hold the "clock" button down until it starts blinking. Use the "Tune Seek Track" button up for hours, down for minutes to set the clock. Hit the "clock" button again to save the setting.
To set the clock on a 2000 Land Rover Discovery, turn on the ignition without starting the engine. Press and hold the "Clock" button until the hours begin to flash, then use the "Seek" buttons to adjust the hour. Press the "Clock" button again to set the minutes, and adjust them similarly using the "Seek" buttons. Once the correct time is set, press the "Clock" button one final time to confirm and exit the setting mode.
To set the clock in a 2000 Mitsubishi Mirage, first, turn on the ignition without starting the engine. Press and hold the "Clock" button until the display starts flashing. Use the "H" (Hour) and "M" (Minute) buttons to adjust the time, then press the "Clock" button again to confirm and exit the setting mode.
Push the set button and within 10 seconds press the seek and scan buttons.
hold clock button and use the seek or other button underneath while holding the clock button
To fix the clock in a 2000 Pontiac Grand Prix, start by turning the ignition key to the "On" position without starting the engine. Press and hold the "Hour" and "Minute" buttons on the radio or dashboard until the clock display starts blinking. Use the "Hour" button to set the hour and the "Minute" button to set the minutes. Once set, the clock should automatically save the time after a few seconds.