To set the time on a 2000 Chevy 3500, turn the ignition key to the "On" position without starting the engine. Press and hold the "Hour" button to set the hour, and then press the "Minute" button to set the minutes. Once you have the correct time displayed, simply release the buttons, and the time will be saved. Make sure to check that the time is correct after setting it.
How do you set the timing on a 2000 Chevy blazer (V6)
Consult the owners manual.
First, if you have two equations like, for instance .90x+2000 and .40x+3500 then you would set them equal to each other like this ( .90x+2000=.40x+3500). Then you would solve for x by simplifying the equations as far down as you can.
they are in parallel they both drain and they both charge. unless u have a cabin\engine compartment switch you cannot isolate them. if you do one will not charge and then you will need it and it will be dead. parallel = 12vdc and series = 24vdc and smoke!
You don't, it's done electronically.
On the Vortec the computer does it all.
In order to set the timing on a 98 Chevy 350 vortex, you have to time with a scan tool that will let you set timing. Or let garage do it
timing is set by pcm, at factory!!
Remove the set screw from the mirror, slide off.
If you set in the passenger seat, it will be the plastic panel beside your right foot.
No, it was not set in the time of World War 2. It was set in the time of around 2000.
need to install rear heat to my Chevy astro it already have rear air condition