This problem has bugged many of us T&C van owners. I have found several answers. I have tried them all to no avail. That doesnt mean that you can give it a go. This is one I tried that actually did make things better (two lights now instead of four flash).
a.. Set Blower motor ON HIGH b.. Set Mode position to Panel c.. Open all A/C outlets d.. Set Temperature to Cold (Both slide pots if equipped) e.. Depress WASH and REAR WIPER button simultaneously for 5 Seconds (Until all LED's light) RESULTS: a.. All LED's will turn on for 5 Seconds b.. Calibration Test is running when REAR WIPER and INTERMITTENT are alternately flashing. Cooldown test is running if A/C and RECIRC are alternately flashing. Wait till all lights stop flashing and only the aft wiper light is flashing. c.. Acceptable results is REAR WIPER LED is the only LED flashing. Push Rear Wiper to exit. d.. After all tests have passed, Calibration Diagnostics and Cooldown can be run separately. COOLDOWN TEST ENTRY a.. Set Blower motor ON HIGH b.. Set Mode position to Panel c.. Open all A/C outlets d.. Set Temperature to Cold (Both slide pots if equipped) e.. Depress WASH and A/C simultaneously for 5 Seconds NOTE: Prior to start of test, If the evaporator is already cold, the system will fail test. To correct, operate system with A/C OFF and the blower motor ON high for three minutes prior to starting test.
RESULTS: a.. All LED's will turn on for 5 Seconds b.. Cooldown Test is running when A/C and RECIRC. are alternately flashing. If A/C and RECIRC. are flashing simultaneously, Cooldown has failed. I you.. It did seem to help most folks. Its a shame that no Chrysler dealer in my area is even aware of this problem. If my machanic had known about this he could have dealt with it when he changed the battery. Good Luck!!
The lights are blinking because there may be a problem with the electrical connection or a malfunction in the lighting system.
Decorative blinking lights work in a series. As long as the series is completed and a blinking specific light is in place you have a beautiful display of blinking decorative lights.
The LED lights are blinking on and off because they are designed to do so as a part of their normal operation.
The lights are blinking in the house because there may be an issue with the electrical wiring or a problem with the light bulbs.
Caution lights.
indicator lights means the vehicle is turning
Troubleshoot for possible failure of gear position sensor (external transmission part). Diags should reveal this.
The lights are blinking on and off because there may be an issue with the electrical connection or a problem with the light bulb itself.
Turn signal lights that double as parking (marker lights) when not blinking.
Blinking lights on a laptop are a way of sending signals to the users. All of the lights mean different things. For a listing of what the lights mean on your laptop please see the manual that came with the laptop.
Three blinking yellow lights mean the deadlock is locked from inside. Guest is in the room
They are called traffic lights or traffic signals. -------------------------------------------------------- *** 2nd Answerer Says: Some parts of the country call them stoplights (as opposed to go-lights or caution-lights) and there is a variation called "blinking lights". "Blinking lights can be blinking red in all four directions to designate a four-way stop or full-stop in two directions & cautionary slow-down (blinking yellow) the other two directions.