To remove the door from a 2005 Chevy Malibu Classic, first, ensure the window is fully closed for access. Disconnect the negative battery cable and remove any interior door panel clips and screws to access the wiring harness and door latch. Next, support the door with a jack or stand, remove the hinge bolts on the door and body, and carefully lift the door away from the hinges. Replace the bushing as needed before reattaching the door.
it means your car needs a service
u have to pull the driveshaft knock out the seal and install a new one, but if it is leaking the bushing needs to be replaced and u would need a bushing driver to install it. u can purchace a seal and bushing kit but the bushing is harder to replace
Its the Primary o2 Sensor (pre-cat), needs to be replaced
the gas cover just needs to be pushed and then it opens... There is no button
Axle seal is bad and needs to be replaced
Apparently your rear trunk latch needs adjusted.
any vehicle that is water cooled and has a radiator needs antifreeze.
To flat tow a 2005 Malibu classic, one needs to remove the two IPC fuses. These fuses are located in the driver's side dash fuse box. After pulling these fuses, attach the vehicle to the towing vehicle.
Needs a good tune up?
radio internal error.. a dealer needs to send this out for repair.
You may have a blown head gasket. This needs to be repaired before you drive the vehicle or you can blow your engine.
every 3000 miles filter and oil needs changed. but if you think sooner thats fine.