remove the few screws you can see then lift up on the door panel. if it wont move look harder for more screws the panel should pop right up.
no no
No.
open the drivers side door and on the side of the dash is a panel that if you pull straight off you will find the fuse panel
i believe 3 screws on the bottom of panel, pop square tab in door handle compartment with flathead, unscrew, and another under ashtray dish, gently lift panel out
No
To replace the window switch in your 2004 Dodge Intrepid you need to remove the door panel. Once the door panel is removed there are two T-20 Torx screws that hold the switch to the door panel. I have included a step by step auto repair video below, that shows how to accomplish this.
There are 10 Phillips screws holding the door panel on. First you would need to remove those. Then you can remove the door panel from the door. On the backside of the door panel you would need to remove the plugs from the backside of the switches. Then you can remove the screws that hold the switch into place on the door panel.
There is a panel located between the end of the dash board and the drivers door. Open the door, take off the cover, and the flasher cube is on the top left of the fuse panel.
#8 in the fuse panel next to the steering wheel in the door jam area. it need a 20 yellow amp.
In the lower front corner of the front fender. It is accessed by removing the tire and a battery access door panel in the inner fender well.
Yes, 2nd Generation Intrepid was made from 1999 through 2004 IDENTICAL Cars Actually, it was 1998 through 2004.
First remove the speaker grillNext remove all of the Phillips head screws from the speaker area,door pull,inside door handle and also door panel.The door panel should now be easy to remove.Disconnect any latching rods and wires from the backside of the door panel.