0
What else can I help you with?
What pully do you run the power steering belt to on a 1983 350 Chevy Silverado truck?
crank pulley.
How do you reinstall the power steering pump pully on a 1995 Chevy silverado 350 v8?
How do you remove power steering pulley on a 1990 ck truck
Can you Adjust the idler pully 1991 Chevy silverado?
No you can not. If belt is loose, are won't fit then you have the wrong belt. The belt tensioner is spring loaded and that is what tightens the belt.
How do you take off the water pump pully off of a 91 Chevy Lumina without the pully turning?
wrap the belt around the pully to hold pully still
How do you fix a broken serpentine belt pulley on a 1998 2.2liter Chevy cavalier?
remove the bolt on the pully or use a pully remover depending on the style of pully and put new one on.
How do you by pass a 2000 Chevy cavalier air conditioner?
Bypass pully...ebay.com
Where is the harmonic balancer on a 1998 Chevy Venture?
It is on the front of the motor, it will be the bottom most pully.
Is there timing on 1991 Chevy S-10?
the mark, scale is on the left side of the ceank pully
How do you adjust serpentine belt on a 1990 Chevy truck?
you dont they are self adjusting with the tentioner pully...
Removal of water pump pulley 1994 Chevy cavalier 2.2?
I have a knocking noise near the water pump pully or idler arm pully on my 94 chevy cavalier 2.2 motor when its at idle, if i give it more gas the noise will go away do you know what this could be? i took off the tension idle pully and checked the bearing and it was fine.
How do you put a fan belt on a 1992 Chevy silverado?
a 92 Silverado 350 uses a single serpentine belt that is tensioned by a spring loaded idler pully. When facing the engine from the front of the vehicle, the tensioner is near the top of the engine slightly left of center. Using a breaker-bar and socket, remove tension from the idler pully and simultaneously slide the serpentine belt off one of the other pulleys. I usually pick the alternator pully since it's so close. Note the path of the old belt and make certain that the new belt is installed along the identical path. Put the belt on all pullies, including the idler pully and hold it with slight tension near the alternator pully, then turn the idler pully again and slide the belt over the alternator and release pressure from the idler pully. Visually inspect the path of the entire belt to make certain that it is properly installed before starting the engine. Don't let anyone stand to the side of the engine when starting it for the first time, since a mis-installed pully can be ripped apart quickly and relatively large pieces of reinforced rubber can really hurt when they hit you.
Fix 1989 Chevy Astro pully pump?
pulley pump???? i know the 89 astro and i do not know what you mean?
