0
To remove the rear seat, pull up on the front of the seat bottom, it should be hooked in place by spring type clips. After you get the front edge up, pull forward and up then remove the seat bottom from the car.This will now expose the bolts/screws that hold the top of the back seat in place. Look below and there should be a couple of screws holding the seat back to the body. Remove these and then you can lift the seat back up and out.
What else can I help you with?
How do you fix the CD player in a 2001 Chevy Impala?
Have it repaired or replace the radio. Either way, you need to remove the whole unit.....
What does the word takeout mean in horse racing?
Takeout means to out-run the whole herd.
How do you replace the dimmer switch on a 1988 Chevy Berreta?
You have to pull the steering wheel off to get the whole turn signal stat out and replace the whole thing.
How do you fix the gas gauge on a 2001 impala?
I have an 05 impala and had problems with the speedometer and fuel gauge. The only way to fix it was to replace the whole instrument cluster. Pretty easy to do, only took about 45 minutes.
Anyone know how to fix a 2001 Impala radio that is intermittent?
The dealer wants to replace my whole radio. I'm looking for answers first.
How do you fix dash board light on 2007 Chevy uplander?
you CANT U HAVE TO REPLACE THE WHOLE CLUSTER...
How do you fix a burned out driver's climate control switch light on a 2002 Chevy Impala?
To fix a burned out light on the driver's climate control switch in a 2002 Chevy Impala, you will need to access the climate control unit, remove it from the dashboard, and replace the light bulb with a new one. This may involve taking apart the center console to access the climate control unit. It's recommended to consult the vehicle's manual or seek professional help if you are unsure about the process.
Why is there no sound in 2003 Chevrolet Impala?
the whole car
How do you remove rear passenger brake lights bulbs on Chevy impala 2006?
My rear brake light went out the same week I bought my 06 Impala! I just went to Wal Mart and checked the book for what size bulb, and to replace it , open your trunk and there's some black plastic wing nut looking things.... it was very easy to change... just unscrew them and the whole tail light will come out.... then you just take the bulb out, replace it, then put the light back into place and put the wingnuts back on :) Hope this helps!
How do you replace a CV boot on a 2000 Chevy s10 4x4?
It is way easier to replace the whole halfshaft. Espiacially if you have never done a bot on this type of axle shaft.
How do you replace drive shaft 2000 Chevy Blazer?
I have a leak on my drive shaft left front 2000 cheve Blazer I would like to replace the whole unit
How do you remove a 1997 Chevy S10 shift knob?
the shifter is all in one. you have to replace the whole shifter. the nob is attached
