The sway bar is not adjustable, but you can replace the bushings.
there should be a rear sway bar
salvage yard
20 mm
Replace the whole sway bar link.
To replace the front sway bar bushings on a 2003 Ford Windstar, first raise the vehicle and secure it on jack stands. Then, locate the sway bar and remove the bolts securing the sway bar brackets to the frame. After removing the brackets, slide off the old bushings and replace them with new ones, ensuring they are properly seated. Finally, reattach the sway bar brackets, tighten the bolts, and lower the vehicle back to the ground.
1. Jack up the rear of the car and put it on stands. 2. Remove the bolts and hardware from the ends of the sway bar. 3. Unbolt the sway bar brackets from the crossmember and take the sway bar out. 4. Install the new sway bar tightening the bracket bolts tightly. 5. Tighten the end nuts and bolts so that 2/3 of the threads are exposed. 6. The rest of the installation is the reverse of taking them out.
13 ft lbs. See related link for a picture.
The links go on the end on the sway bar and hook to the suspension. Bushings are used to connect the sway bar to cars frame.
sway bar
A sway bar is a torsion bar mounted laterally on a suspension and is designed to reduce side sway. The sway bar attempts to accomplish this by transferring movement from one side of the suspension to the other. This is done through the connection of a torsion bar to each side of an axle by flexible links. (Sway bar links)
buy new bushings if needed for the rod and tighten the clamps holding the bushings
A little more information. Year/model. Some sway bar links become loose because of wear and the links continue to work but make a noise when the front end hits a bump. Other sway bar links will break altogether and the vehicle will lean excessivly when going around a corner.