When you try to start engine is there any noise,such as clicking from area of starter?If you can hear a clicking , this usually indicates poor connections.To trouble shoot starter problem, the first thing i would do is determine if it is starter or solenoid.To do this ,you need a remote starter switch,connected to starter solenoid.Solenoid is located either on the starter,or on firewall in engine bay,depending on what vehicle you have. if you dont have a remote switch, you can short the solenoid terminals with a screw driver.When shorting, if the solenoid is good you will hear clicking.If you dont hear anything , replace the solenoid.If you hear clicking and starter doesnt work, pull the starter out and replace .
Remove it and have it bench tested at your local auto parts store.
With a test light.
Not enough info. Car heater? House heater? Gas? electric? Water?
To trouble shoot a device the problem with the device has to be stated. With a UPS the first thing to check is the batteries.
Trouble shooting is to diagnois whats going on with your computar.
Short the windings and perform resistance testing. Check your rectifier for shorted and/or opened diodes (likely open).
Yes
An air compressor is a complicated machine , in order to trouble shoot any problems , there must be a detailed description of the problem/s.
It is just an aid to help trouble shoot the problem. Older TVs didn't tell you what might be wrong.
trouble shoot it
The starter is usually the person who shoot the gun or is the person recording time in Track and Field
A trouble shoot has the same capacity as a troubleshooter and a troubleshooter is an expert in discovering and eliminating the cause of trouble in mechanical equipment, power lines, ect. ** Yes, or in laymans terms: To go through various ways or paths to find out what the problem is.