Check out: http://www.jeepforum.com/forum/showthread.php?t=229760 Also read: http://www.jeepforum.com/forum/showthread.php?t=202276
When you turn the key off and lock the doors, there will be a red light on the top of the dash that flashes while the alarm arms.
To reset the security system on a 2004 Jeep Grand Cherokee Laredo, first ensure the vehicle is in the "Off" position. Then, insert the key into the ignition and turn it to the "On" position without starting the engine. Wait for about 10 minutes until the security light stops flashing, then turn the key back to "Off" and remove it. This should reset the system, allowing you to start the vehicle normally.
Push in and turn it counterclockwise.
To reset the security system on a 2002 Jeep Grand Cherokee, insert the key into the ignition and turn it to the "On" position without starting the engine. Leave it in this position for about 10 minutes until the security light on the dashboard turns off. Turn the key back to the "Off" position, then start the engine. If the system still doesn't reset, you may need to consult the owner's manual or a professional mechanic for further assistance.
No such switch. Just put the key in the ignition and turn it on, or unlock with the remote.
Turn the key to the on position, wait ten minutes, then it will turn over.
You need to have the abs codes read, repair the cause, and the light will turn itself off.
try unplugging the battery for a while. that may turn it off IF you fixed the problem that turned it on.
The turn signal light can be accessed from the back of the turn signal light assembly. Push the lightbulb connector in and turn at the same time. The lightbulb will come out and can be changed.
The light is on because the air bag computer has detected a malfunction and set a code. The failure will have to be repaired to get the light off.
this ? shouldn't be in animal abuse but i think it means it is going to turn
The abs light is on because there is a problem with the system and will remain on until the system is fixed. As long as the light is on the abs will not function.