answersLogoWhite

0

A slim jim (more technically known as a lockout tool) is a thin strip of metal (usually spring steel) roughly 60cm long and about 2-4 cm wide originally marketed under that name by HPC Inc., a manufacturer and supplier of specialty locksmithing tools. Slim Jims are used to unlock automobile doors without use of a key or lock pick. It acts directly on the levers and interconnecting rods that operate the door, completely avoiding the complexity of dealing with the lock mechanism itself. The hooked end of the tool is slipped between a car's window and the rubber seal, catching the rods that connect to the lock mechanism. With careful manipulation, the door can be opened.[1]

Unskilled use of the tool will often detach the lock rods, leaving the lock inoperable even with the key. This is often a clue that someone has attempted to break into a car. Newer cars have also incorporated internal defenses against this tool such as barrier blocks on the bottom of the window, preventing entry, and also shrouding the operating rods and the lock cylinder to prevent manipulation of internal linkages. Others have designed the operating rods to be easily disconnected when engaged with a lateral force - as is often created by the lifting action of the tool.[citation needed] It has been reported that in modern vehicles there is a chance for setting off the side airbag deployment system of the vehicle, possibly causing injury to a person attempting to use a slim jim. However, according to research by the National Highway Traffic Safety Administration, this has not been verified and manufacturers state it is impossible.[2] An episode of MythBusters showed experimenters that were also unable to deploy an airbag with slim jim.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

How to remove factory radio from 2004 ford f150?

How to remove the factory radio and disconnect wirring harnes in a 2004 f150 ford truck


Where is Egr valve location 2004 ford f150 5.4l?

The EGR valve, on a 2004 Ford F150 5.4 liter engine, is located on the top of the engine near the back. The valve is difficult to identify without prior mechanical knowledge.


How do i deactivate the 2004 ford f150 truck alarm?

i lost the ignition key anl keyless remote on my for f150 2004 truck


Where is the vehicle speed sensor located on a 2004 Ford F150?

On a 2004 Ford F150, the vehicle speed sensor is located on the driveshaft of the transmission. Some models of 2004 Ford F150s use an ABS sensor instead of a vehicle speed sensor.


How do you disable seatbelt alarm on a Ford F-150 2004?

How do I disable seat belt alarm for a Ford F150 2004


How do you replace turn signal flasher on 2004 ford f150 truck?

location of flasher relay ford 150 2004


How do you shut off alarm after changing battery on 2004 Ford F150 pickup?

To shut off the alarm after changing the battery on a 2004 Ford F150, you typically need to unlock the driver's door using the key or the remote. If the alarm is still active, insert the key into the ignition and turn it to the "On" position without starting the engine. This should disable the alarm system. If that doesn't work, you can also try disconnecting the battery again for a few minutes and reconnecting it.


Would 2004 ford F150 stock rims fit a 2002 F150?

yes as long as its a five lug wheel


How much horse power does a stock 4.6L V8 2004 Ford F150 have?

231 bhp. and 300 for the 5.4L F150


Where is the fuse block on a 2004 F150 Ford truck?

The fuse block on F150 2004 and later is located behind right front passengers lower kick panel.


Bolt pattern ford f150 4x4 2004?

6 x 135mm


What side is bank 1 on a 2004 Ford F150?

The passenger side of the engine