Disconn the batt.
Pull the airbag.
Pull the Steering wheel. (puller needed)
Finagle the pin out.
Pull the lock cyl.
Reverse the order and you should be on the road in an hour/
howdo you change an ignition switch on a 1996 gmc jimmy howdo you change an ignition switch on a 1996 gmc jimmy
2005 yukon BACK DOOR CATCH LOCK
Gmc does not use inertia/reset switches.
That 92 GMC van doesn't have a relay for ignition. Power for the ignition is supplied from the ignition switch.
Engine seized? Dead or weak battery? Loose or corroded battery cables? Bad starter solenoid? Bad starter? Bad neutral safety switch? Bad ignition switch?
The 1996 GMC Yukon brake lights work by receiving power from the brake light relay switch. The brake light relay switch is connected to the brake pedal.
Where. Is the oil pressure switch on a 2003 yukon xl
were is the rear door relay switch located on a 2003 yukon
Your new key chip needs to be mated to the cars computer, this needs to be done at the dealer
take it to the dealer........
Check the ignition coils and the crank sensor for the Yukon. Either one of these could be bad and cause the problem.
gm products do not have fuel cutoff switches.