Most tachs have a green wire that goes to the negative side of the coil, and at least two more wires for hot and ground. Sometimes there are two hots. One for the tach and one for the light. Check inside your tach to determine which wire goes to ground, and you should be able to figure it out from there.
The tach should have 3 wires a 12v accessory, ground, and rpm wire. The rpm wire is the blue one on the distributor.
If single phase - 2 wire service > two wires If single phase - 3 wire service > three wires If three phase - 3 wire service > three wires If three phase - 4 wire service > four wires US residential service is usually single phase 3 wire service: Two hots and neutral.
3
To properly wire a light fixture with 3 sets of wires, first identify the hot (black), neutral (white), and ground (green or bare) wires in each set. Connect the hot wires together, the neutral wires together, and the ground wires together using wire nuts. Then, connect the fixture's hot wire to the group of hot wires, the neutral wire to the group of neutral wires, and the ground wire to the group of ground wires. Finally, secure all connections with electrical tape and install the light fixture according to the manufacturer's instructions.
To properly wire a plug with 3 wires, you need to connect the live wire (usually brown), the neutral wire (usually blue), and the earth wire (usually green and yellow) to their respective terminals in the plug. Make sure to follow the correct wiring diagram and secure the wires tightly to prevent any electrical hazards.
To wire an outlet with 3 wires, connect the black wire to the brass screw, the white wire to the silver screw, and the green or bare wire to the green screw. Make sure to turn off the power before starting and follow all safety precautions.
To properly wire a ceiling light with 3 wires, you will need to connect the black wire to the live or hot wire, the white wire to the neutral wire, and the green or bare wire to the ground wire. Make sure to turn off the power before starting and follow the manufacturer's instructions for your specific light fixture.
To properly wire a light fixture with 3 wires, you need to connect the black wire to the live or hot wire, the white wire to the neutral wire, and the green or bare wire to the ground wire. Make sure to turn off the power before starting and follow the manufacturer's instructions for your specific fixture.
To properly wire an outlet with 3 wires, connect the black wire to the brass screw, the white wire to the silver screw, and the green or bare wire to the green screw. Make sure to turn off the power before working on the outlet to avoid electrical shock.
To wire a GFCI outlet with 3 wires, connect the black wire to the brass screw, the white wire to the silver screw, and the green or bare wire to the green screw. Make sure to follow the manufacturer's instructions and turn off the power before starting the installation.
On a 3 wire dryer cord there is no green wire. The white wire coming from the outlet is connected to ground or the green screw. The black and red wires are the hot wires.
To wire a 220v plug with 3 wires correctly, connect the black wire to the brass terminal, the white wire to the silver terminal, and the green or bare wire to the green terminal. Make sure to follow the manufacturer's instructions and turn off the power before starting.